Juniper Networks MX480 - Manual (Page 337)

APPENDIX F
MX480 Cable Connector Pinouts
• RJ-45 Connector Pinouts for an MX Series Routing Engine ETHERNET Port on page 313
• RJ-45 Connector Pinouts for MX Series Routing Engine AUX and CONSOLE
Ports on page 314
RJ-45 Connector Pinouts for an MX Series Routing Engine ETHERNET Port
The port on the Routing Engine labeled ETHERNET is an autosensing 10/100-Mbps
Ethernet RJ-45 receptacle that accepts an Ethernet cable for connecting the Routing
Engine to a management LAN (or other device that supports out-of-band management).
Table 46 on page 313 describes the RJ-45 connector pinout.
Table 46: RJ-45 Connector Pinout for the Routing Engine ETHERNET Port
Signal Pin
TX+ 1
TX– 2
RX+ 3
Termination network 4
Termination network 5
RX– 6
Termination network 7
Termination network 8
Related
Documentation
MX480 Routing Engine Description on page 32 •
• RJ-45 Connector Pinouts for MX Series Routing Engine AUX and CONSOLE Ports on
page 314
313 Copyright © 2013, Juniper Networks, Inc.