Juniper Networks MX480 - Manual (Page 263)

Related
Documentation
Preventing Electrostatic Discharge Damage to an MX480 Router on page 248 •
• MX480 DC Power Supply Description on page 44
• Replacing an MX480 DC Power Supply on page 230
Replacing the MX480 Cable Management Brackets
To remove the (see Figure 124 on page 239 ):
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.
2. Loosen the captive screws on either side of the chassis.
3. Remove the cable management brackets.
To install the (see Figure 124 on page 239 ):
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.
2. Position the on the front sides of the chassis.
3. Insert the tabs into the slots.
4. Tighten the screws completely.
Figure 124: Removing the Cable Management Brackets
Related
Documentation
• Preventing Electrostatic Discharge Damage to an MX480 Router on page 248
• MX480 Cable Management Brackets on page 49
• Installing the MX480 Router Cable Management Bracket on page 81
239 Copyright © 2013, Juniper Networks, Inc.
Chapter 14: Replacing MX480 Hardware Components