Juniper Networks MX480 - Manual (Page 193)

Figure 85: Removing the Fan Tray
Installing the MX480 Fan Tray
To install the fan tray (see Figure 86 on page 170 ):
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.
2. Grasp the fan tray handle, and insert it straight into the chassis. Note the correct
orientation by the
this side up label on the top surface of the fan tray.
3. Tighten the captive screws on the fan tray faceplate to secure it in the chassis.
169 Copyright © 2013, Juniper Networks, Inc.
Chapter 14: Replacing MX480 Hardware Components