Juniper Networks MX480 - Manual (Page 212)

The following drive has been verified to work in the RE-1800 Routing Engines:
• SSD SLC 32 GB
To replace a storage drive:
1. Disable and deactivate the storage drive.
2. Remove the storage drive.
a. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
connect the strap to an ESD point on the appliance.
For more information about ESD, see Prevention of Electrostatic Discharge Damage
on VXA Series Content Engines.
b. Unfasten the thumbscrew that secures the access door in front of the storage drive
slots, and open the door.
c. Slide the lock on the ejector to the unlocked position.
d. Carefully slide the drive out of the slot.
3. Reinstall a storage drive.
a. Carefully align the sides of the drive with the guides in the slot.
b. Slide the drive into the slot until you feel resistance, carefully ensuring that it is
correctly aligned.
c. Close the access door and tighten the thumbscrew to secure the door.
4. Mount the new storage drive.
Related
Documentation
Returning a Hardware Component to Juniper Networks, Inc. on page 327 •
Replacing Connections to MX480 Routing Engine Interface Ports
• Replacing the Management Ethernet Cable on an MX Series Router on page 188
• Replacing the Console or Auxiliary Cable on an MX480 Router on page 189
Replacing the Management Ethernet Cable on an MX Series Router
One Ethernet cable with RJ-45 connectors is provided with the router. To replace the
cable connected to the
ETHERNET port:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.
2. Press the tab on the connector, and pull the connector straight out of the port. Figure
93 on page 189 shows the connector.
3. Disconnect the cable from the network device.
Copyright © 2013, Juniper Networks, Inc. 188
MX480 3D Universal Edge Router Hardware Guide