Kawasaki D Series Controller MPVDCONTV113E-3 - Manual (Page 178)

TROUBLESHOOTING
1-175 August 9, 2005
D SERIES CONTROLLER
TROUBLESHOOTING AND COMPONENT REPLACEMENT
Ka a a w s k
ERROR CODE P1014 Cannot execute because program already in use.
An attempt to execute the same program using the EXECUTE and PCEXECUTE is
made.
⇒
Allow the program to complete executing and re-execute.
_____________________________________________________________________
ERROR CODE P1015 Cannot delete, in use by another command.
Cannot COPY, DELETE or XFER command because program is being edited or ex-
ecuted.
⇒
Complete program editing before using COPY, DELETE or XFER commands.
⇒
Allow program execution to complete before using COPY, DELETE or XFER com-
mands.
_____________________________________________________________________
ERROR CODE P1016 Cannot delete, used in program.
An attempt is made to delete a variable that is used in a program.
⇒
Deletion of variables used in programs is not allowed by the AS system.
_____________________________________________________________________
ERROR CODE P1017 Cannot delete a program in Editor.
Attempting to delete a program that is open in editor mode.
⇒
Exit editor mode, and then delete the selected program.
_____________________________________________________________________
ERROR CODE P1018 KILL or PCKILL to delete program.
Occurs when an attempting to delete a program that is still on the stack (selected).
⇒
Select another program or KILL/PC KILL the program, then delete.
_____________________________________________________________________