Kawasaki D Series Controller MPVDCONTV113E-3 - Manual (Page 195)

TROUBLESHOOTING
D SERIES CONTROLLER
TROUBLESHOOTING AND COMPONENT REPLACEMENT
1-192 August 9, 2005
Ka a a w s k
ERROR CODE P2059 [SerialFlash] data write error.
The specified file cannot be written to the 1KA board.
Main causes include:
1. The file is corrupt.
2. The serial flash memory on the 1KA board is set to write-protect.
⇒
Ensure the 1KA board serial flash memory is not set to write-protect .
⇒
Replace the 1KA board serial flash memory.
_____________________________________________________________________
ERROR CODE P2060 [SerialFlash] File or directory doesn’t exist.
The specified file or directory does not exist in the serial flash memory on the 1KA
board.
⇒
Ensure the file or directory exists in the serial flash memory .
⇒
Create a new file or directory.
_____________________________________________________________________
ERROR CODE P2061 File does not exist in floppy.
When accessing the floppy disk, the specified file cannot be found on the floppy disk.
⇒
Ensure an existing file name is specified .
_____________________________________________________________________
ERROR CODE P2062 [FDD/PC_CARD] Failure in writing data per verify function.
When the verify function is enabled in AUX 0208, the destination and source data are
compared when writing data to a floppy disk or PC card. This error occurs if the data
does not match.
⇒
Replace the floppy disk/PC card.
⇒
If this error recurs, replace the 1KA/1KF boards or harness.
_____________________________________________________________________
ERROR CODE P2063 [FDD/PC_CARD] Faulty response from verify function.
Setting enable or disable for the verify function in AUX 0208 failed.
⇒
Re-execute .
⇒
If this error recurs, replace the 1KF board.
_____________________________________________________________________