Kawasaki D Series Controller MPVDCONTV113E-3 User Manual

Page 85

Advertising
background image

TROUBLESHOOTING

D SERIES CONTROLLER

TROUBLESHOOTING AND COMPONENT REPLACEMENT

1-82

August 9, 2005

Ka a a

w s k

ERROR CODE E1039

Encoder INC-pulse error. (Jt XX)

Occurs when the encoder A and B incremental pulses are abnormal. The encoder
INALM bit is sent with the serial data=1.

Power
circuit

Battery

Encoder

Encoder

1FG/1HG board

Robot

Controller

1KB board

Encoder I/F

Servo

CPU

Encoder +12 VDC power supply

Main causes include:
1. Noise related malfunction.
2. Defective encoder or encoder harness.
3. Defective 1KB or 1FG/1HG board.
4. Servo spot weld gun.

–Loose connection at tool changer.
–Defective tool changer harness.

⇒

Replace encoder, replace 1KB board.

⇒

Check connections at encoder, 1FG/1HG board, and separation harness.

⇒

Ensure the 1KB board is properly seated into the card rack.

⇒

Check for continuity in the machine harness and separation harness.

⇒

Replace 1FG/1HG board.

⇒

Inspect the servo gun and tool changer harnesses; replace as necessary.

For additional information on error code E1039, see section 1.4.

_____________________________________________________________________

ERROR CODE E1040

Encoder MR-sensor error. (Jt XX)

The state of the MR sensor in the encoder does not match with JT ENCODER in one
rotation.

⇒

Replace the encoder or encoder harness.

⇒

Replace signal harness.

⇒

Replace 1KB board.

_____________________________________________________________________

Advertising