Lanier LP222cn - Manual (Page 154)

Preparing for Printing
35
A
Quit all applications currently running.
B
Insert the CD-ROM into the CD-ROM drive.
The installer starts.
Auto Run may not work with certain operating system settings. If this hap-
pens, launch “Setup.exe” on the CD-ROM root directory.
C
Select an interface language, and then click [OK].
The default interface language is English.
❒ The printer driver with the selected language will be installed. The English
printer driver is installed when the following language is selected: Cestina,
Magyar, Polski, Portugues, Suomi.
D
Click [PostScript 3 Printer Driver].
Add Printer Wizard starts.
E
Click [Next >].
F
Click [Local printer], and then click [Next >].
G
Click [Create a new port:].
H
Click [Standard TCP/IP] in [Create a new Port], and then click [Next].
I
Click [Standard TCP/IP], and then click [OK].
J
Click [Next] in the [Add Standard TCP/IP Printer Port Wizard] dialog box.
K
Enter the printer name or IP address in the [Printer Name or IP Address] box,
and then click [Next >].
When screen for Device selection appears, select “RICOH NetworkPrinter
Driver C Model”.
L
Click [Finish] in the [Add Standard TCP/IP Printer Port Wizard] dialog box.
M
Check that the name of the printer whose driver you want to install is se-
lected, and then click [Next >].
N
Change the printer name if you want, and then click [Next >].
Select the [Yes] check box to configure the printer as default.
O
Click [Next >].
P
Specify whether or not to print a test page, and then click [Next >].
Q
Click [Finish].
The printer driver installation starts.