Lanier LP222cn - Manual (Page 303)

Monitoring and Configuring the Printer
184
❖ Mode settings
You can set the Bluetooth operation mode to {private} or {public}.
msh> btconfig {private | public}
• The default is {public}.
devicename
Use the “devicename” command to display and change the printer name.
❖ View settings
msh> devicename
❖ Printer name configuration
msh> devicename name “string”
• Enter a printer name using up to 31 alphanumeric characters.
• Set single names for each printer.
❖ Printer name initialization
msh> devicename clearname
• Reset the printer name to its default.
dhcp
Use the “dhcp” command to configure DHCP settings.
❖ View settings
The following command displays the current DHCP settings.
msh> dhcp
❖ Configuration
You can configure DHCP.
msh> dhcp “interface_name” {on|off}
• Click {on} to enable DHCP. Click {off} to disable DHCP.
• If the DNS server address and domain name are obtained from DHCP, be
sure to click {on}.
• ip1394 can be specified only when the IEEE 1394 interface is installed.
• wlan can be specified only when the IEEE 802.11b interface is installed.
Interface name Interface configured
ether Ethernet interface
ip1394 IEEE 1394 interface
wlan IEEE 802.11b interface