Lanier LP222cn - Manual (Page 320)

Monitoring and Configuring the Printer
201
❖ Deleting sysContact
msh> snmp clear contact
❖ SNMP v1v2 function configuration
msh> snmp v1v2 {on | off}
• Specify “on” to enable, and “off” to disable.
❖ SNMP v3 function configuration
msh> snmp v3 {on | off}
• Specify “on” to enable, and “off” to disable.
❖ SNMP TRAP configuration
msh> snmp trap {v1 | v2 | v3} {on | off}
• Specify “on” to enable, and “off” to disable.
❖ Remote Configuration Authorization configuration
msh> snmp remote {on | off}
• Specify “on” to enable, and “off” to disable.
❖ SNMP v3 TRAP configuration display
msh> snmp v3trap
msh> snmp v3trap {1- 5}
• If a number from 1-5 is entered, settings are displayed for that number only.
❖ Configuring a sending address for SNMP v3 TRAP
msh> snmp v3trap {1-5} {ip| ipx} address
❖ Configuring a sending protocol for SNMP v3 TRAP
msh> snmp v3trap {1-5} active {ip/addr | ipx} {on | off}
❖ Configuring a user account for SNMP v3 TRAP
msh> snmp v3trap {1-5} account “account_name”
• Enter an account name using up to 32 alphanumeric characters.
❖ Deleting an SNMP v3 TRAP user account
msh> snmp v3trap {1-5} clear account
❖ Configuring an SNMP v3 encryption algorithm
msh> snmp v3auth {md5 | sha1}
❖ Configuring SNMP v3 encryption
msh> snmp v3priv {auto | on}