Lanier LP222cn - Manual (Page 269)

Making Printer Settings Using the Control Panel
150
❖ Trans. Speed
You can select the transmission speed for IEEE 802.11b.
• Auto
• 11 Mbps
• 5.5 Mbps
• 2 Mbps
• 1 Mbps
❒ Default: Auto
❖ SSID
You can set an SSID in the infrastructure mode and the 802.11 Ad hoc
mode.
Select [View] to check the SSID. Select [Enter ID] to set SSID.
• View
• Enter ID
❒ Select [?] to enter [/] for the SSID. Also, [¥] appears when printing the
configuration page, read it as [/].
❒ Default: blank (ASSID)
❒ Characters used are ASCII 0x20-0x7e (32 bytes).
❒ An SSID is set automatically to the nearest access point if no SSID has
been set.
❒ If no SSID has been set for the 802.11 ad hoc mode, an SSID is set au-
tomatically and the same SSID is used for the 802.11 ad hoc mode and
the infrastructure mode.
❒ If blank is specified in SSID for 802.11b adhoc mode or adhoc mode,
“ASSID” appears.
❒ An SSID can also be set using Web Image Monitor. For details, see
Web Image Monitor Help.
❖ WEP Setting
You can specify whether or not to activate WEP settings.
• Active
• Not Active
❒ Default: Not Active
❒ The WEP key can be entered using a hexadecimal number or an ASCII
character sequence.