Lanier LP222cn - Manual (Page 253)

Making Printer Settings Using the Control Panel
134
❒ The signal is rated [Good] if signal strength is 86%-100%, [Fair] if 61%-85%,
[Poor] if 31%-60%, and [Unavailable] if 0%-30%. If the signal is unstable or
unavailable, remove any obstructions or move the printer to a place to re-
ceive the signal.
❒ Using wireless devices or microwave sources nearby will affect the signal
transmission.
Resetting the IEEE 802.11b (Wireless LAN) Settings
Follow the procedure below to reset the wireless LAN setting on the [Maintenance]
menu.
❒ [Comm. Mode], [Channel], [Trans. Speed], [WEP Setting], and [SSID] can be select-
ed on the [Host Interface] menu.
A
Press the {Menu} key.
The [Menu] screen appears.
B
Press the {T} or {U} key to display [Maintenance], and then press the {#
Enter} key.
C
Press the {T} or {U} key to display [WL.LAN Defaults], and then press the
{# Enter} key.
D
Press the {# Enter} key.
The wireless LAN setting is reset.
After about three seconds, the initial screen appears.
Maintenance menu parameters
This section explains about parameters that can be set on the Maintenance
menu.
❖ Color Regist.
You can specify Auto Adjust or Fuser Adjust for this feature.