Lanier LP222cn - Manual (Page 494)

G1398504_1.00 Copyright © 2005 74
Troubleshooting
Error & Status Messages on the Control
Panel
This section explains what the messages that appear on the control panel mean
and what to do when a particular message appears.
❖ Messages (in alphabetical order)
Messages Description Recommended Action
Add Toner
Black
The printer is out of toner
(Black). Replace the toner cartridge
(Black).
See p.28 “Replacing the Ton-
er Cartridge” .
Add Toner
Cyan
The printer is out of toner (Cy-
an). Replace the toner cartridge
(Cyan).
See p.28 “Replacing the Ton-
er Cartridge” .
Add Toner
Magenta
The printer is out of toner (Ma-
genta). Replace the toner cartridge
(Magenta).
See p.28 “Replacing the Ton-
er Cartridge” .
Add Toner
Yellow
The printer is out of toner (Yel-
low). Replace the toner cartridge
(Yellow).
See p.28 “Replacing the Ton-
er Cartridge” .
Add Toner
XXX/XXX
The printer is out of the indicat-
ed toner(s).
XXX: Yellow/Magenta/Cy-
an/Black
Replace the toner cartridge of
the indicated color(s).
See p.28 “Replacing the Ton-
er Cartridge” .
Calibrating... The printer is calibrating the
color. Wait a while.
Call Service: EC
Power Off On
/ Call Service if
error reoccurs
A communication error sent
from the engine to the control-
ler. A communication error sent
from the engine to the control-
ler.
Cannot check
Signal in Ad hoc
An attempt to check the radio
signal was made while the
communication mode was set
to [Ad hoc] in the interface set-
tings. To check the radio signal , se-
lect Infrastructure in the com-
munication mode settings.