Lanier LP222cn - Manual (Page 490)

Cleaning and Adjusting the Printer
70
D
Press the {# Enter} key.
When following message appears on the display, press the {# Enter} key.
E
Compare the colors on the printed image density test sheet with those
on the Image Density Adjusting Card.
❒ If the image density of the Image Density Adjusting Card is equal to the
framed part of the test sheet, do not adjust the image density value.
❒ If the image density of the Image Density Adjusting Card is equal to the
density shown above the frame, select “-” as the image density setting. If
the image density of the Image Density Adjusting Card is equal to the den-
sity shown below the frame, select “+” as the image density setting.
F
Press the {U} or {T} key to select the color you want to adjust, and then
press the {# Enter} key.
G
Press the {U} or {T} key to set the image density value, and then press
the {# Enter} key.
❒ You can adjust the image density in 21 increments, from -10 to +10. In-
creasing the value makes printouts darker and decreasing the value makes
printouts lighter.
❒ Pressing the {U} or {T} key increases or decreases the value in incre-
ments of one.
To adjust another color, repeat steps F and G .
H
Press the {Online} key.
The initial screen appears.
Prt. Test Sheet
Press # to start
Printing...
Image Density:
Black
Black:
(-10 +10) 0