Lanier LP222cn - Manual (Page 266)

Making Printer Settings Using the Control Panel
147
❒ When DHCP is set to on, the subnet mask cannot be changed. To
change it, set DHCP to off. Contact your network administrator for infor-
mation about the network configuration.
❒ Default: 000.000.000.000
❖ Gateway Address
You can specify the gateway address.
❒ When DHCP is set to on, the gateway address cannot be changed. To
change it, set DHCP to off. Contact your network administrator for infor-
mation about the network configuration.
❒ Default: 000.000.000.000
❖ Frame Type (NW)
You can select the frame type for NetWare.
• Auto Select
• Ethernet II
• Ethernet 802.2
• Ethernet 802.3
• Ethernet SNAP
❒ Default: Auto Select
❖ Active Protocol
You can select the active protocol.
• TCP/IP
• NetWare
• SMB
• AppleTalk
❒ Default: All Active
❖ Ethernet Speed
You can select the network speed to operate the printer.
• Auto Select
• 10Mbps Half D.
• 10Mbps Full D.