Lanier LP222cn - Manual (Page 430)

Paper and Other Media
10
Thick Paper
Adhesive labels
OHP transparencies
Number of sheets that can
be set • Tray 1: 530
• Tray 2, Tray 3 (Paper Feed Unit Type 3000): 530
• Bypass Tray: 100
❒ Make sure paper is not stacked higher than the upper limit
mark (T) inside the tray. Make sure paper is not stacked higher
than the paper guides inside the bypass tray.
Both-side printing Possible
Paper thickness 105 - 199 g/m 2 (28 - 53 lb.)
• [Thick Paper 1]: 105 - 165 g/m 2 (28 - 44 lb.)
• [Thick Paper 2]: 165 - 199 g/m 2 (44 - 53 lb.)
Printer setup Press [Paper Input] menu, [Paper Type] and then [Thick Paper 1] or
[Thick Paper 2] on the control panel.
Printer driver setup Click [Thick1] or [Thick2] in the [Type:] list.
Enabled paper feeding tray Bypass Tray
• [Thick Paper 1]: 30
• [Thick Paper 2]: 10
❒ Make sure paper is not stacked higher than the paper guides
inside the bypass tray.
Both-side printing Not possible
Additional cautions • Print speed is slightly slower than when using plain paper.
Printer setup Press [Paper Input] menu, [Paper Type], and then [Labels] on the
control panel.
Printer driver setup Click [Labels] in the [Type:] list.
Enabled paper feeding tray Bypass Tray: 50
❒ Make sure paper is not stacked higher than the paper guides
inside the bypass tray.
Both-sided printing Not possible
Additional cautions Print speed is slightly slower compared to plain paper.
Printer setup Press [Paper Input] menu, [Paper Type], and then [Transparency] on
the control panel.