Nortel Networks NN43001-301 - Manual (Page 186)

186 ISL installation
B1 E1 L2 M1 Q0 V1 X4 Y0 &C0 &D0 &G0 &J0 &L0 &P0 &Q0 &R0 &S0 &X0
S00:000 S14:AAH S18:000 S21:00H S22:76H S23:17H S25:005 S26:001
S27:40H
Telephone numbers:
&Z0=
&Z1=
&Z2=
&Z3=
Figure 73
ISL dedicated mode, using dialup Hayes Smartmodem 2400
Dedicated mode using PRI/DTI trunks
In this configuration, the DCHI or MSDL is connected to a High Speed Data
Module (HSDM) or Asynchronous/Synchronous Interface Module (ASIM).
See
Figure 74 "ISL dedicated mode: using PRI/DTI trunk" (page 187) . The
HSDM or ASIM is connected to a Data Line Card (DLC). The call is then
connected to the far end through the DLC to DTI trunk path.
To establish the D-channel in this configuration, set up the HSDM or ASIM
at one end in hot line mode. The hot line DN must be coordinated with
personnel at the far end, then programmed in LD11. The preprogrammed
hot line DN is dialed by the system. If the call cannot be established, the
system continues to dial the hot line number continuously until the call is
connected.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.