Nortel Networks NN43001-301 - Manual (Page 299)

NT8D7205 299
For cabinets without an I/O filter assembly, this cable transports the
T1 signal from the QPC720 PRI pack to the NCTE telephone company
interface.
• Standard length - 50 ft (15.3 m)
• Construction - Individually foil-shielded, twisted pairs, 24 AWG (0.511
mm), stranded
• P1 Connector - 15-pin, female, subminiature D with jackscrews
• P2 Connector - 15-pin, male, subminiature D, with slide-latch (optional
spring-latch loose-packed with cable assembly)
Table 111
QCAD133 wire list
Color From To PRI signal
WHITE P1-1 P2-1 XTIP (transmit tip) to
telephone company
BLACK P1-9 P2-9 XRING (transmit ring) to
telephone company
GRN SHLD P1-2 nc GND (ground)
RED P1-3 P2-3 RTIP (receive tip) from
telephone company
BLACK P1-11 P2-11 RRING (receive ring) from
telephone company
RED SHLD P1-4 nc GND (ground)
NT8D7205
This cable is used to transport the 2Mb digital signal from the I/O panel
at the cabinet bulkhead to the Network Channel Terminating Equipment
(NCTE) telephone company interface.
• Standard length - 15.3 m (50 ft.)
• Construction - Individually foil-shielded, twisted pairs, 24 AWG (0.511
mm), stranded
• P1 Connector - 9-pin, female, subminiature D with jackscrews
• P2 Connector - 9-pin, male, subminiature D, with jack screws
Table 112
NT8D7205 wire list
Color
From
(pack end) To
(I/O end)
Signal
White P1-6 P2-6 XTIP (transmit)
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.