Nortel Networks NN43001-301 - Manual (Page 210)

210 1.5 Mb PRI implementation
Table 76
DS-1 line interface pinout for NTBK04 cable
From 50-pin
MDF connector
To DB-15
Signal
name
Description
pin 48 pin 1 T transmit tip to
network
pin 23 pin 9 R transmit ring to
network
pin 25 pin 2 FGND frame ground
pin 49 pin 3 T1 receive tip from
network
pin 24 pin 11 R1 receive ring from
network
—End—
Procedure 31
Enabling the NTRB21 TMDI card
Step Action
1 Enter the following command in LD 96 to enable the NTRB21 TMDI
card:
ENL TMDI x ALL
where x is the NTRB21 TMDI card number (DLOP). The card
number associated with a NTRB21 TMDI card is based on the slot in
which the card is installed.
2 If in PRI mode, enter the following command in LD 96 to software
enable the D-channel:
ENL DCH y
where y is the DCH port number that was assigned in LD 17.
3 Within about 30 seconds, the D-channel layer 3 should be
established. To confirm, enter the following command in LD 60 to
request the current status of the D-channel:
STAT DCH (N)
The system response is:
DCH N EST OPER
This means that the D-channel is established and operational.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.