Nortel Networks NN43001-301 - Manual (Page 212)

212 1.5 Mb PRI implementation
PRI cards must be configured before defining the DCH links or PRI
applications.
Prompts which do not show a response can be left as default. For more
information on any of these prompts, refer to Software Input Output
Administration (NN43001-611).
Before installing PRI cards in an IP expansion cabinet/Media Gateway,
first configure the expansion cabinet/Media Gateway for IP connectivity.
Refer to LD 117 in the Software Input Output Reference — Maintenance
(NN43001-711) for further information.
To implement PRI on the system:
Procedure 33
Implementing basic PRI
Step Action
1 Add a PRI card. step 6
2 Add a DCHI card. "LD 17 - Adding a PRI card" (page 212)
3 Define a PRI customer. "LD 15 - Defining a PRI customer" (page
214)
4 Define a PRI service route. "LD 16 - Configuring an ISDN service
route" (page 215)
5 Define service channels (B-channels) and PRI trunks. "LD 14 -
Defining service channels and PRI trunks" (page 216)
6 Define clock synchronization. "LD 73 - Defining system timers and
clock controller parameters" (page 217)
—End—
LD 17 - Adding a PRI card
Prompt Response Description
REQ CHG Change existing data.
TYPE CFN Configuration data block.
CEQU YES Changes to common equipment.
PRI loop x card x For Large Systems and Small Systems
TMDI (Yes)
No TMDI Card (Mode set to PRI OR TRK) Option 11C Cabinet Other card
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.