Nortel Networks NN43001-301 - Manual (Page 275)

PRI software implementation 275
Prompt Response Description
RLS XX Software release of far-end. This is the current software release
of the far-end. If the far-end has an incompatible release of
software, it prevents the sending of application messages, for
example, ’Network Ring Again.
RCAP MSL MSDL RCAP capability.
OVLR <CR> Allow or disallow overlap receiving on a D-channel. Default is
NO.
LAPD YES (NO) Change LAPD parameters. Enter carriage return if timers are
left at default. The following timers are prompted only if LAPD is
set to YES. They are all left at default during initial setup.
- T23 1-(20)-31 Interface guard timer checks how long the interface takes to
respond. In units of 0.5 seconds (default 20 = 10 seconds).
T200 2-(3)-40 Retransmission timer in units of 0.5 seconds (default 3 = 1.5
seconds).
- N200 1-(3)-8 Maximum number of retransmissions.
- N201 4(260) Maximum number of octets in information field.
- K 1-(7)-32 Maximum number of outstanding unacknowledged frames
(NAKS).
LD 15 - Defining a PRI customer
Prompt Response Description
REQ: NEW
CHG Add new data.
Change existing data.
TYPE: NET Networking data.
CUST 0-99 Customer number
Range for Large System, Call Server 1000E, and
Media Gateway 1000E
0-31 Range for Small System, Media Gateway 1000B
LDN XXXX Enter the customer’s Listed Directory Number.
AC2 Access Code 2. Enter call types (type of number) that use
access code 2. Multiple responses are permitted. This prompt
only appears on NARS equipped systems. If a call type is not
entered here, it automatically defaults to access code 1.
NPA E.164 National.
NXX E.164 Subscriber.
INTL International.
SPN Special Number.
LOC Location Code.
ISDN YES Customer is equipped with ISDN.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.