Nortel Networks NN43001-301 - Manual (Page 276)

276 2.0 Mb PRI implementation
Prompt Response Description
PNI 1-32700 Customer private network identifier. This number is unique to
this customer in the private network. For example, it is used as
part of the setup message for feature operation such as Network
Ring Again and Network ACD. Note that if PNI is set to zero (0),
NRAG and NACD does not work.
HNPA NPA Telephone area code for this system. Sent in the setup message
as calling line identification.
HNXX NXX Telephone local exchange code for this system. Sent in the
setup message as calling line identification.
HLOC XXX Home location code (NARS)
LSC 1-9999 One to four digit Local Steering Code established in the
Coordinated Dialing Plan (CDP). The LSC prompt is required for
Calling Line ID and Network ACD.
LD 16 - Defining a PRI service route
Prompt Response Description
REQ NEW CHG Add new data.
Change existing data.
TYPE RDB Route data block.
TKTP xxx Trunk type.
DTRK YES Digital trunk route.
DGPT PRI2 2.0 Mb PRI. Prompted only if PRA = YES in LD15.
ISDN YES ISDN option.
MODE PRI Route used for PRI only.
PNI 1-32700 Customer private network identifier. Is the same as the CDB
PNI at far-end.
IFC xx Interface type.
CHTY BCH Signaling type. Prompted if DTRK is YES. D-channel signaling
for B-channels.
CTYP aaa
<CR> Call Type. Enter the call type to associate with the outgoing
route for direct dialing using the trunk access code (instead of
NARS access code).
INAC YES Insert Access Code. Permits the NARS AC1 or AC2 access
code to be reinserted automatically on an incoming ESN call.
This prompt only appears on a TIE route and is set to "YES" for
features such as Network ACD to function.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.