Nortel Networks NN43001-301 - Manual (Page 280)

280 2.0 Mb PRI implementation
Prompt Response Description
PERS ttt Persistence Timer for Group II problems.
Enter 0-256 msec in increments of 2 msec. Default is 50
(=100ms).
CLRS ttt Clearance Timer for Group II problems. Enter 0 - 256 msec in
increments of 2 msec. Default is 50 (=100ms).
OOSC nnn Out-of-Service Counter.
Range for nnn of 0-255 with a default of 5.
LD 73 - Changing trunk pad category values
Prompt Response Description
REQ CHG Change data.
TYPE PRI2 2.0 Mb PRI.
FEAT PADS
PDCA # PAD table-0 is default and is hard coded.
The following prompts define the pad levels.
The receiving pad code is r and the transmission pad code is t. These entries have the range 0-15.
The pad values (in decibels) relating to these codes are shown after this table.
ONP r t On-premises extension.
DSET r t Meridian Digital set.
Prompted only if the 2.0 Mb Gateway feature is equipped.
OPX r t Off-premises extension.
DTT r t Digital TIE trunks.
SDTT r t Digital Satellite TIE trunks.
NTC r t Nontransmission compensated.
TRC r t Transmission compensated.
DCO r t Digital COT, FEX, WAT, and DID trunks.
VNL r t Via Net Loss.
DTO r t 2.0 Mb PRI2 digital TOLL office trunks.
ACO r t Analog CO or WATS trunks.
AFX r t Analog FEX trunks.
ADD r t Analog DID trunks.
SATT r t Analog satellite TIE trunks.
ATO r t Analog TOLL office trunks.
PRI2 r t 2.0 Mb PRI trunk.
Prompted only if the 1.5/2.0 Mb Gateway feature is equipped
and TYPE=2.0 Mb PRI.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.