Nortel Networks NN43001-301 - Manual (Page 83)

Set up the NT6D11AB, NT6D11AE, NT6D11AF DCHI 83
Figure 37
NT6D11 DCH with ISL low-speed programming jumper settings
Port addressing modes
Port 0 Mode selection
Port 0 is used to select whether the asynchronous ESDI port is be disabled
or not. Refer to
Table 24 "Port 0 mode selection" (page 83) .
Note: The asynchronous ESDI port must be set to "disabled".
Table 24
Port 0 mode selection
Port Mode Switch Setting
SW1.1 SW1.2
Not used 0 -
Asynchronous ESDI 1 0
Port disabled 1 1
Port 1 mode selection
Port 1 is used to select the standard or expanded D-channel addressing
mode on the NT6D11AB/AE/AF. Refer to
Table 25 "Port 1 mode selection"
(page 84) .
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.