Nortel Networks NN43001-301 - Manual (Page 272)

272 2.0 Mb PRI implementation
Table 101
NTBK05DA pinouts
From:
50-pin MDF
connector
To:
9-pin connector
color Signal
pin 23 pin 6 Black R0
pin 48 pin 7 White T0
pin 50 pin 9 Bare R0/T0 FGND
pin 24 pin 2 Black R1
pin 49 pin 3 Red T1
pin 25 pin 5 Bare R1/T1 FGND
NTBK05CA pinouts
The pinouts for the NTBK05CA cable are as follows:
Table 102
NTBK05CA pinouts
From:
50-pin MDF
connector To:
Transmit coax
connector To:
Receive coax
connector To:
50-pin MDF
connector
pin 23 Inner conductor — —
pin 48 outer conductor — —
pin 24 — Inner conductor —
pin 49 — outer conductor —
pin 21 — — pin 49
pin 46 — — pin 48
PRI software implementation
The following information describes the process required to program basic
2.0 Mb PRI on the system.
PRI cards must be configured before defining the DCH links or PRI
applications.
Prompts which do not show a response are left as default. For more
information on any of these prompts, refer to Software Input Output
Administration (NN43001-611).
Task summary
Note: Before installing PRI cards in IP expansion cabinets or Media
Gateway systems, configure them for IP connectivity. Refer to LD 117
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.