Nortel Networks NN43001-301 - Manual (Page 233)

Basic ISL implementation 233
Prompt Response Description
IFC SL1 Interface type.
DCHL 1-9 PRI card number (Must match entry for CDNO).
SIDE NET (USR) Net: network, the controlling switch.
User: slave to controller.
RLS XX Software release of far-end. This is the current
software release of the far-end. If the far-end
has an incompatible release of software, it
prevents the sending of application messages,
for example, Network Ring Again.
CLOK D-channel clock type for signaling.
EXT Source of D-channel clock is external to DCHI
card (in this case, the DTI/PRI circuit card).
Normally, EXT is used for PRI/ISL.
Do not confuse this clock with the E1 span Clock
Controller found on the NTAK10/79. This clock
is in reference to the DCHI synchronous mode of
operation. Note: If directly connecting two DCHI
ports without modems, set "CLOK" to "EXT" on
one side and "INT" on the other.
LAPD YES (NO) Change LAPD parameters. Enter <cr> to leave
timers at default value. The following timers
are prompted only if LAPD is set to YES. The
following can all be left at default during initial
setup.
T23 1-(20)-31 Interface guard timer checks how long the
interface takes to respond. In units of 0.5
seconds (default 20 = 10 seconds).
T200 2-(3)-40 Retransmission timer in units of 0.5 seconds
(default 3 = 1.5 seconds).
N200 1-(3)-8 Maximum number of retransmissions.
N201 4(260) Maximum number of octets in information field.
K 1-(7)-32 Maximum number of outstanding
unacknowledged frames (NAKS).
LD 73 - Configuring the D-channel for ISL
Prompt Response Description
REQ NEW CHG Add new data. Change existing data.
TYPE DDB Digital data block.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.