Nortel Networks NN43001-301 - Manual (Page 274)

274 2.0 Mb PRI implementation
Prompt Response Description
ADAN NEW DCH xx
CHG DCH xx
OUT DCH xx Add a primary D-channel (any unused SDI port.)
Change a primary D-channel.
Out the primary D-channel, where:
xx = 1-9 for Option 11C main cabinet, 11-19 for IP expansion
cabinet 1, 21-29 for IP expansion cabinet 2, 31-39 for IP
expansion cabinet 3, and 41-49 for IP expansion cabinet 4.
xx = 11-14, 21-24, 31-34, 41-44 of the first, second, third and
fourth Media Gateway, respectively.
CTYP MSDL
TMDI Card type where:
MSDL = The NTBK51BA Downloadable D-Channel
Daughterboard.
TMDI = TMDI (NTRB21) card.
CDNO 1-50 Card slot number used as the primary DDCH/DCHI.
Card slots 10, 20, 30, 40, and 50 are only applicable for
D-channel configuration of ISL or VNS.
PORT 1 PORT set to "1".
USR PRI D-channel is for ISDN PRI only.
Note: 2.0 Mb only supports PRI or SHA user mode.
IFC xx Interface type.
DCHL xx PRI card number carries the D-channel. Must match entry made
for the "CDNO" associated with the "DCHI" prompt above.
Where: xx = 1-9 for Option 11C main cabinet, 11-19 for IP
expansion cabinet 1, 21-29 for IP expansion cabinet 2, 31-39 for
IP expansion cabinet 3, and 41-49 for IP expansion cabinet 4.
xx = 11-14, 21-24, 31-34, 41-44 of the first, second, third and
fourth Media Gateway, respectively.
PRI2 <CR> Additional PRI Loops controlled by this DCHI. Remember
one DCHI can control up to 16 PRI loops going to the same
destination. For the system, the maximum limit is eight loops.
OTBF 1-(16)-127 Number of output request buffers. Note: for a single PRI link,
leave this prompt at default (16). Add 5 output request buffers
per additional link.
SIDE NET (USR) Prompted only if IFC is set to SL1. NET = network, the
controlling switch USR = slave to the controller
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.