Nortel Networks NN43001-301 - Manual (Page 81)

Set up the NT6D11AB, NT6D11AE, NT6D11AF DCHI 81
Table 21
Protocol selection switch settings
Protocol Switch Setting
SW3.1 SW3.2
DPNSS1 0 0
ISDN 1 1
Valid switch combinations
The following are the only allowable switch setting combinations (not
including address switch settings).
Port 0
Port 0 can be configured as asynchronous ESDI, or disabled. If the port is
configured as disabled, it will not be visible to the system CPU. Refer to
Table 22 "Port 0 settings" (page 81) .
Table 22
Port 0 settings
Mode Switch setting
SW1.1 SW1.2 SW3.1 SW3.2
Asynchronous ESDI 1 0 0 0
Asynchronous ESDI 1 0 1 1
Port disabled 1 1 - -
Port 1
The following are the only valid emulation mode combinations. If the port
is configured as disabled, it will not be visible to the system CPU. Refer to
Table 23 "Port 1 settings" (page 81) .
Note: The ISDN emulation must be selected.
Table 23
Port 1 settings
Mode Emulates Switch setting
SW2.1 SW2.2 SW3.1 SW3.2
DPNSS1 NT5K35 0 0 0 0
ISDN NT6D11 0 0 1 1
Expanded
DPNSS1 NT5K75 0 1 0 0
Port disabled 1 1 - -
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.