Serial peripheral interface (spi), Nxp semiconductors – NXP Semiconductors P89LPC9321 UM10310 User Manual
Page 84
UM10310
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2010. All rights reserved.
User manual
Rev. 2 — 1 November 2010
84 of 139
NXP Semiconductors
UM10310
P89LPC9321 User manual
12. Serial Peripheral Interface (SPI)
The P89LPC9321 provides another high-speed serial communication interface, the SPI
interface. SPI is a full-duplex, high-speed, synchronous communication bus with two
operation modes: Master mode and Slave mode. Up to 3 Mbit/s can be supported in either
Master or Slave mode. It has a Transfer Completion Flag and Write Collision Flag
Protection.
C0H
Data byte in
I2DAT has been
transmitted;
NACK has been
received
No I2DAT action
or
0
0
0
0
Switched to not addressed SLA
mode; no recognition of own SLA or
General call address.
no I2DAT action
or
0
0
0
1
Switched to not addressed SLA
mode; Own slave address will be
recognized; General call address
will be recognized if I2ADR.0 = 1.
no I2DAT action
or
1
0
0
0
Switched to not addressed SLA
mode; no recognition of own SLA or
General call address. A START
condition will be transmitted when
the bus becomes free.
no I2DAT action
1
0
0
1
Switched to not addressed SLA
mode; Own slave address will be
recognized; General call address
will be recognized if I2ADR.0 = 1. A
START condition will be transmitted
when the bus becomes free.
C8H
Last data byte in
I2DAT has been
transmitted
(AA = 0); ACK
has been received
No I2DAT action
or
0
0
0
0
Switched to not addressed SLA
mode; no recognition of own SLA or
General call address.
no I2DAT action
or
0
0
0
1
Switched to not addressed SLA
mode; Own slave address will be
recognized; General call address
will be recognized if I2ADR.0 = 1.
no I2DAT action
or
1
0
0
0
Switched to not addressed SLA
mode; no recognition of own SLA or
General call address. A START
condition will be transmitted when
the bus becomes free.
no I2DAT action
1
0
0
1
Switched to not addressed SLA
mode; Own slave address will be
recognized; General call address
will be recognized if I2ADR.0 = 1. A
START condition will be transmitted
when the bus becomes free.
Table 76.
Slave Transmitter mode
…continued
Status code
(I2STAT)
Status of the I
2
C
hardware
Application software response
Next action taken by I
2
C
hardware
to/from I2DAT
to I2CON
STA
STO
SI
AA