Texas Instruments Digital Signal Processor SM320F2812-HT - Manual (Page 144)

M51
M50
M47
Bit 0 Bit(n-1) (n-2) (n-3) (n-4)
Bit 0 Bit(n-1) (n-2) (n-3) (n-4)
CLKX
FSX
DX
DR
M44
M48
M49
M43
LSB MSB M52
SM320F2812-HT
SGUS062B – JUNE 2009 – REVISED JUNE 2011 www.ti.com
Table 6-58. McBSP as SPI Master or Slave Timing Requirements (CLKSTP = 10b, CLKXP = 1) (1)
MASTER SLAVE
NO. UNIT
MIN MAX MIN MAX
M49 t
su(DRV-CKXH)
Setup time, DR valid before CLKX high P – 10 8P – 10 ns
M50 t
h(CKXH-DRV)
Hold time, DR valid after CLKX high P – 10 8P – 10 ns
M51 t
su(FXL-CKXL)
Setup time, FSX low before CLKX low 8P + 10 ns
M52 t
c(CKX)
Cycle time, CLKX 2P 16P ns
(1) Not production tested.
Table 6-59. McBSP as SPI Master or Slave Switching Characteristics (CLKSTP = 10b, CLKXP = 1) (1) (2)
MASTER SLAVE
NO. PARAMETER UNIT
MIN MAX MIN MAX
M43 t
h(CKXH-FXL)
Hold time, FSX low after CLKX high 2P ns
M44 t
d(FXL-CKXL)
Delay time, FSX low to CLKX low P ns
Disable time, DX high impedance following last data bit from FSX
M47 t
dis(FXH-DXHZ)
6 6P + 6 ns
high
M48 t
d(FXL-DXV)
Delay time, FSX low to DX valid 6 4P + 6 ns
(1) Not production tested.
(2) 2P = 1/CLKG
For all SPI slave modes, CLKX has to be minimum eight CLKG cycles. Also, CLKG should be LSPCLK/2 by setting CLKSM = CLKGDV
= 1. With maximum LSPCLK speed of 75 MHz, CLKX maximum frequency is LSPCLK/16 , that is 4.5 MHz and P = 13.3 ns.
Figure 6-45. McBSP Timing as SPI Master or Slave: CLKSTP = 10b, CLKXP = 1
144 Electrical Specifications Copyright © 2009 – 2011, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Link(s): SM320F2812-HT