Texas Instruments Digital Signal Processor SM320F2812-HT - Manual (Page 51)

INT1
to
INT12
INT14
C28x
TINT2
TINT0
PIE CPU-TIMER 0
CPU-TIMER 2
(Reserved for TI
system functions)
INT13
TINT1
CPU-TIMER 1
(Reserved for TI
system functions)
XINT13
SM320F2812-HT
www.ti.com SGUS062B – JUNE 2009 – REVISED JUNE 2011
In the F2812 device, the timer interrupt signals (TINT0, TINT1, TINT2) are connected as shown in
Figure 4-2 .
A. The timer registers are connected to the Memory Bus of the C28x processor.
B. The timing of the timers is synchronized to SYSCLKOUT of the processor clock.
Figure 4-2. CPU-Timer Interrupts Signals and Output Signal (See Notes A. and B.)
The general operation of the timer is as follows: The 32-bit counter register TIMH:TIM is loaded with the
value in the period register PRDH:PRD. The counter register, decrements at the SYSCLKOUT rate of the
C28x. When the counter reaches 0, a timer interrupt output signal generates an interrupt pulse. The
registers listed in
Table 4-1 are used to configure the timers. For more information, see the TMS320x281x
System Control and Interrupts Reference Guide ( SPRU078 ).
Copyright © 2009 – 2011, Texas Instruments Incorporated Peripherals 51
Submit Documentation Feedback
Product Folder Link(s): SM320F2812-HT