AASTRA SIP-DECT (Release 3.0)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 101)

SIP–DECT OM System Manual Release 3.0 8 OM Management Portal (OMP)
Aastra depl-1624/1.0 Page: 101 (241)
General
For a description of the parameters which can be set in the General tab, please refer to the
description of the System settings page of the OMM Web service (see chapter 7.4.1). The
corresponding parameters can be found there in the General settings , Syslog , OM
Integrated Messaging and Alerting service and Voice mail page sections.
Net parameters
For a description of the parameters which can be set in the Net parameters tab, please refer
to the description of the System settings page of the OMM Web service (see chapter 7.4.1).
The corresponding parameters can be found there in the IP parameters page section.
Notes:
•
The 802.1p signalling priority parameter (OMP) corresponds to the VLAN priority Call
control parameter (OMM Web service).
•
The 802.1p voice priority parameter (OMP) corresponds to the VLAN priority Audio
parameter (OMM Web service).
DECT
For a description of the parameters which can be set in the DECT tab, please refer to the
description of the System settings page of the OMM Web service (see chapter 7.4.1). The
corresponding parameters can be found there in the DECT settings and Downloading new
firmware to portable parts page sections.
The following settings are only available in the OMP.
•
Paging area size : Select the number of paging areas for the SIP–DECT system. A paging
area can consist of up to 16 RFPs. The configuration of the paging areas is done in the
Paging areas menu of the OMP (see chapter 8.7.2).
•
Auto-create on subscription : Activate this option if an unbound subscription of portable
parts should be allowed. Please see the SIP–DECT; OM Handset Sharing & Provisioning;
User Guide /27/ for details.
WLAN
For a description of the parameters which can be set in the WLAN tab, please refer to the
description of the System settings page of the OMM Web service (see chapter 7.4.1). The
corresponding parameters can be found there in the WLAN settings page section.
Restarting or Updating the OMM
For a restart of the OMM, press the Restart button in the System settings menu. For more
information see chapter 7.4.1.1.
To update the OMM software, press the Update button in the System settings menu. For
more information see the chapters 7.4.1.2 and chapter 9.12.
8.5.2 “Statistics” Menu
The Statistics menu provides system statistics information. It contains a table with
numerous system statistics counters which can be used to check the system behavior. The
menu is only available in monitor mode.