AASTRA SIP-DECT (Release 3.0)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 77)

SIP–DECT OM System Manual Release 3.0 7 OMM Web Service
Aastra depl-1624/1.0 Page: 77 (241)
Note: To ease the first installation of a DECT system, the subscription is enabled
permanently while at least one PP (with IPEI) is set up within the database and no
PP is subscribed. After successful subscription of the first PP the subscription will
still be enabled for 24 hours.
Subscription steps, done by PP
After the PP configuration is complete on the OMM and the OMM is allowing new
subscriptions, each PP must subscribe to the system.
On each PP handset, the administrator or user must subscribe to the SIP–DECT system
through the System/Subscriptions menu. The specific PARK code for the SIP–DECT system
should be entered in order to subscribe to the system.
Please note: The PARK code in numeric format can be found at the top-right corner of the
Portable Parts OMM web page. Each SIP–DECT deployment will have a
unique PARK code that was provided with the OMM Activation kit.
If the administrator configured a global or handset-specific Portable Part DECT
authentication code, the administrator/user must enter in the code before the PP will
subscribe to the system.
In case of “wildcard subscription”, please note that an additional ID may be configured (see
sub section Wildcard Subscription), which has to be typed then.
7.7.3.1 Subscription with Configured IPEI
The PP data to be assigned to the subscribing PP are identified by the IPEI. The
identity of a PP (IPEI) is already known by the system before the PP attempts to
subscribe. Unknown PPs are not allowed to subscribe in this mode.
To enable subscriptions, press the Start button of the section Subscription with configured
IPEIs on the Portable parts page.