AASTRA SIP-DECT (Release 3.0)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 213)

SIP–DECT OM System Manual Release 3.0 10 Maintenance
Aastra depl-1624/1.0 Page: 213 (241)
Please note: The TFTP server must allow writing new files, this is usually not standard.
The transfer of core files may be disabled by setting
OM_CoreDumping=0
.
10.3.7 DECT Monitor
Please note: The DECT Monitor has been replaced by OMP but the DECT Monitor can still
be used without warranty for SIP–DECT installations with a standard PARK
and up to 256 RFPs all within paging area 0.
For a better error detection in the SIP–DECT system the DECT Monitor can be used. The
DECT Monitor is an MS Windows based stand alone program. It provides the possibility to
give a real time overview of the current IP DECT base station and telephone states in the
SIP–DECT system.
The following features are provided by the DECT Monitor:
•
Reading out of the DECT configuration of an SIP–DECT system.
•
Configuration can be stored in an ASCII file.
•
Display of DECT transactions IP DECT base station <–> telephone in clear tabular form
with highlighting of handover situations. Real-time display.
•
Display of further events concerning the status or actions of IP DECT base stations and
telephones of the SIP–DECT system.
•
All events can also be recorded in a log file.
•
Display of the synchronization relations between the RFPs.
•
Monitoring of systems with up to 256 IP DECT base stations and 512 PPs.
•
Reading out and display of IP DECT RFP statistics data, either for a single IP DECT RFP
or for all IP DECT RFPs.
•
Display of DECT central data of the SIP–DECT system.
The DECT Monitor program can only be used when the DECT monitor checkbox is
activated on the flag in the OMM System settings web page (see also chapter 7.4.1).