AASTRA SIP-DECT (Release 3.0)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 185)

SIP–DECT OM System Manual Release 3.0 9 Configuration und Administration Aspects
Aastra depl-1624/1.0 Page: 185 (241)
# e.g. 003042ABCDEF.cfg
# all RFPs will also load the <OWN-MAC>.cfg file
# If this parameter is set to yes(,y,1) there have to be a valid mac.cfg!
# until the MAC is excluded with OM_PersonalConfig_<MAC>=n
OM_PersonalConfigAll=0 # BOOL
# DO load the individual file for the RFP with mac 003042FFF0D0
# no matter what OM_PersonalConfigAll says
#OM_PersonalConfig_003042FFF0D0=y
# DO NOT load the individual file for the RFP with mac 003042ABCDEF
# no matter what OM_PersonalConfigAll says
#OM_PersonalConfig_003042ABCDEF=n # BOOL
##############################################################################
# OpenMobility system
#
OM_ManagerIpAddress1=192.168.11.100
#OM_ManagerIpAddress2=192.168.11.101
OM_ManagerCountry=100
#OM_ManagerDownloadOverAirUrl=ftp://server/pub # URL to the directory
#OM_ManagerRestoreDbUrl=tftp://server/folder/OMMDATABASE.gz
##############################################################################
##
# RFP (L) 35,36,37,43 software update URL (http, https, tftp, ftp, ftps)
#
#OM_SwImageUrl=ftp://server/iprfp3G.dnld
##############################################################################
# SYSLOG
#
OM_SyslogIpAddress=192.168.11.10
OM_SyslogPort=514
##############################################################################
# NTP
#
#OM_NtpServerName=de.pool.ntp.org
OM_NtpServerIPAddress=131.188.3.220 130.149.17.21
##############################################################################
# reserved options do not used if not requested by Aastra
#OM_CoreDumping=y
#OM_CoreFileSrv=192.168.50.254
#OM_CoreFilePath=/corefiles/
9.9 RFP (L) 35/36/37 IP / RFP (L) 43 WLAN Software Update
The software checks several locations for a software update (software different from the
currently active software). If found then the software is copied to the flash leaving the running
software intact. After successful installation the OMM is informed about the different
software. Activation of the software is then managed by the active OMM. RFPs that do not
have a connection to the OMM activate and start the software immediately.
Locations for SW update are:
•
Attached USB mass storage device with a software image iprfp3G.dnld in its root. The
USB mass storage device must be formatted using the vfat32 file system.
•
If ipdect.cfg supplies the OM_SwImageUrl variable then the URI is used to get the boot
image. Please see chapter 9.8.
•
TFTP server, path and file configured using the OM Configurator or via DHCP.