AASTRA SIP-DECT (Release 3.0)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 182)

SIP–DECT OM System Manual Release 3.0 9 Configuration und Administration Aspects
Aastra depl-1624/1.0 Page: 182 (241)
Parameter settings priority
Some parameters can be set via DHCP / OM Configurator or by using the files “ipdect.cfg” or
“<MAC>.cfg”. If a parameter is provided by more than one of the possible ways, the last
setting has priority. There is the following order:
•
DHCP / OM Configurator
•
ipdect.cfg
•
<MAC>.cfg
It is also possible to remove settings.
Software update settings for current RFPs
A configuration parameter specifies the location of the software that will be installed into the
flash of an RFP (L) 35/36/37 IP / RFP (L) 43 WLAN and activated by the OpenMobility
Manager.
OM_SwImageUrl=ftp://172.30.207.21/openmobility/iprfp3G.dnld
TFTP, FTP(S), HTTP(S) are supported for an RFP (L) 35/36/37 IP / RFP (L) 43 WLAN
software update, please see section 9.11.5.
Times when RFP configuration times are read
The configuration files are read by the RFP application e.g. during startup as shown by the
following figure.