1 creating and changing “digit treatment” entries, Creating and changing “digit treatment” entries – AASTRA SIP-DECT (Release 3.0)- OM System Manual - Installation, Administration and Maintenance EN User Manual
Page 90
SIP–DECT OM System Manual Release 3.0
7 OMM Web Service
Aastra
depl-1624/1.0
Page: 90 (241)
Note:
To support digit treatment and overlap sending, it is necessary to have a dial
terminator configured.
The result of the conversion is not sent to the handset to be displayed or entered in the call
log
The following tasks can be performed on the
Digit treatment
page:
•
creating and changing “Digit treatment” entries (see chapter 7.9.1.1),
•
deleting “Digit treatment” entries(see chapter 7.9.1.2).
7.9.1.1 Creating and Changing “Digit treatment” Entries
1 To configure a new entry press the
New
button on the
Digit treatment
page.
To change the configuration of an existing entry click on the
icon left behind the entry.
The
New digit treatment entry
resp. the
Configure digit treatment entry
dialog opens.
2
External pattern
: enter an external prefix pattern with up to 32 characters that matches
an incoming call number or a number received via LDAP. The prefix to be substituted for
calling party numbers has the same character set as the user telephone number
(e.g.:”+*~#,;.-_!$%&/()=?09aAzZ”).
3
Internal pattern
: enter an internal prefix pattern with up to 32 character that replaces the
external pattern for LDAP / incoming calls or vice versa for outgoing calls. An internal
prefix pattern can be composed of: characters “*”, ”#” and “0” – “9”.
Please note:
The plus character (“+”) can only be dialled and transferred to a call log with
an Aastra 600d / 650c handset with the new handset firmware releases
Aastra 600d 4.00 and Aastra 650c 1.00.
4
Direction
: select one of the following options:
- “Incoming calls”: Rule applies on incoming calls.
- “Outgoing calls”: Rule applies on outgoing calls.
- “Incoming and outgoing calls”: Rule applies on incoming and outgoing calls.
- “Apply on directory only”: Rule applies on LDAP only.
1
For Outgoing Call/Called Number: If the user would dial the number from the redial list
again the same procedure will be applied as for the initial dialling.