AASTRA SIP-DECT (Release 3.0)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 196)

SIP–DECT OM System Manual Release 3.0 9 Configuration und Administration Aspects
Aastra depl-1624/1.0 Page: 196 (241)
•
They lose their RFP base station and search the DECT network without finding another
one:
- active calls are broken;
- PPs stay in searching for network until an air interface is available again.
Note: Handover between PPs located to RFPs which are controlled by different OMMs is
not possible.
When the OMMs get in contact again with each other this inconsistent OpenMobility system
situation will end.
9.14 Managing Account Data for System Access
Each RFP provides different independent access types:
•
the OMM Web service/HTTPS interface (see chapter 7);
•
the OMP (see chapter 8);
The OMM Web service and the OMP are mainly used for configuration and administration.
•
the OM Configurator (see chapter 9.6);
The OM Configurator is mainly used for static local configuration of an RFP.
•
the SSH user shell (see chapter 10.3.5).
The SSH user shell is mainly used from experts for diagnosis.
Each of this these access types uses the same account data.
The account data can be altered at the User account page of the OMM Web service (see
chapter 7.4.3).
The OMM delivers all the necessary account data to all connected RFPs. The RFPs save the
account data inside their permanent memory. This has some implications:
•
An RFP out of the box uses the default account data as long as this RFP is not connected
to the OMM.
•
An RFP which was connected for at least one time with the OMM uses the account data
from the OMM.
•
When the account data are changed on the OMM, any not connected RFPs will continue
to use the older passwords.
9.14.1 Account Types
There are three different account types:
•
Full access: This access type is the “normal” access for all the configuration. Using this
access it is allowed to configure the OMM and each RFP. On the SSH interface of an RFP
this access type allows login for debug information e. g. 'pinging an other RFP to check
visibility.
The factory setting for this account is
Name:
'omm'
Password: 'omm'
Active:
'n/a'