AASTRA SIP-DECT (Release 3.0)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 208)

SIP–DECT OM System Manual Release 3.0 10 Maintenance
Aastra depl-1624/1.0 Page: 208 (241)
10.3.5 SSH user shell
Each RFP offers a lot of commands within the SSH shell. Most of them are useful for
diagnostic and may help experts to resolve failures.
Note: Some commands can harm the system operation.
The SSH access of an RFP is open if
•
the RFP is connected to an OMM and the “Remote Access” is switched on or
•
the RFP is not connected to an OMM.
To activate the SSH access of an RFP which has a connection to an OMM, activate the
Remote access checkbox on the OMM System settings web page (see also chapter 7.4.1).
 In the OMP, the SSH access is activated/deactivated in the General tab of the System
settings menu (see chapter 8.5.1).
10.3.5.1 Login
To log in to the SSH user shell:
1 Open SSH session to the IP DECT base station with the “Full access” user name.
6 Enter the password for the “Full access” account (see also 9.14.1).
The output should look like:
Welcome to IP RFP OpenMobility SIP Only Version 2.1.x
last reset cause: hardware reset (Power-on reset)
[email protected]'s password:
[email protected] >