AASTRA SIP-DECT (Release 3.0)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 116)

SIP–DECT OM System Manual Release 3.0 8 OM Management Portal (OMP)
Aastra depl-1624/1.0 Page: 116 (241)
The Active column shows the following states:
•
– DECT is not enabled and/or RFP not connected.
•
– DECT is enabled and RFP connected, but DECT has not been activated yet.
•
– DECT is enabled and RFP is connected, but RFP is not synchronized and searches
for other synchronized RFPs.
•
– DECT is enabled and RFP is connected and synchronized.
Note: If the Active column is not displayed, you can activate it in the Select columns
dialog, see chapter 8.7.1.7.
Device list in monitor mode
The tasks which can be performed are mode-dependant.
Configuration mode Monitor mode See chapter
Create : create new RFP in detail
panel
8.7.1.2
Configure : configure selected RFP
in detail panel
8.7.1.3
Show details : show selected RFP in
detail panel
8.7.1.4
Delete : delete selected RFP 8.7.1.5