Printronix SL4M - Manual (Page 102)

102
Chapter 4 EMULATION MENU
Select Char
This parameter selects which character to discard when Ignore Mode is
enabled.
• 0 (the default)
• 0 - 255 . Any character from 0 to 255 in decimal.
Do FF at TOF
Determines whether the printer, with media already set at the TOF (Top-of-
Form) position, will advance media to the next TOF position upon receipt of
an FF command.
• Enable (factory default). The printer will advance media from the present
TOF position to the next TOF position upon receipt of an FF command,
causing a blank form.
• Disable . The printer will not advance media from the present TOF
position to the next TOF position upon receipt of an FF command.
IGP100 Compatibl.
This parameter forces the output to correspond with IGP-100 printer output in
cases where there are differences.
The options are Disable (factory default) and Enable.
Expanded Font
Expanded font allows you to print characters in different sizes with specified
parameters and to select which font face to use.
• Scalable (factory default). Uses scalable fonts.
• Block . Uses block fonts.
• Alt Block 1 . Uses alternative block fonts with a different character set.
Scalable Size
This option determines whether scalable characters are sized based on
normal scaling or based on the size of block characters. If the option Block is
set, then the scalable character are made to be the same size as block
characters in the old IGP-X00 printers.
The options are Normal (factory default) and Block.
Forms Handling
This submenu allows the user to handle the form in the following ways:
• Disable (factory default). No effect.
• Auto Eject . Automatically moves to the next TOF if the form is in the
middle of the page, and then ejects a page by performing a form feed
( FF).
• Auto TOF . Automatically does a form feed (FF) to the next top of form if
the form is in the middle of the page.