Printronix SL4M - Manual (Page 265)

General Commands
265
Table 22. General PTX_SETUP Commands
Command Sub-Command Parameter Description
CONFIG LOAD Cfg Cfg can be 0-8. The PTX_SETUP
will load configuration Cfg . If
configuration Cfg was not previously
saved, the operator panel will
display an error message and the
current configuration will be kept.
SAVE Cfg Cfg must be 1-8. This command will
save the current configuration as
configuration
Cfg . If Cfg is not in the
range of 1-8, the command is
ignored.
SETMENU Value;Menu_tag Menu_tag is the name of the menu
as defined in the menu file. Value is
the value to which the menu is to be
set.
POWERUP Cfg Sets the power-up configuration to
Cfg and loads Configuration Cfg .
Cfg can be any value from 0-8,
where 0 is the factory default.
PRINT Cfg Print Configuration Cfg . Cfg can be
a number 1-8, or one of four pre-
defined configurations. The four
non-numeric configurations are
requested using the first character
for the CURRENT, FACTORY,
POWERUP, or ALL configuration(s).
DELETE Cfg Deletes Configuration number Cfg.
Cfg must be in the range of 1-8.
UPLOAD Port;Cfg This command uploads the
configuration stored in location
Cfg
to the port specified by Port . Port
must either be 1284 or SERIAL. Cfg
may be 1-8 or ALL.
DOWNLOAD Cfg This command saves the
configuration data that follows as
configuration
Cfg. Cfg must be 1-8
or END.