Printronix SL4M - Manual (Page 83)

83
TOF Adjust Mode
• Disable (factory default). This option disables the “TOF Adjust” distance
set using the TOF Adjust menu (see TOF Adjust below).
• Enable . This option enables the “TOF Adjust” distance set using the TOF
Adjust menu (see TOF Adjust below).
TOF Adjust
This option sets the distance from the Top Of Form (TOF) that is left blank
(unprinted) after a label has been removed in Tear-Off Strip. Normally printing
is done starting at TOF, but when this mode is enabled the start position for
printing can be adjusted from 0.00 to 0.40 inches from TOF (in increments of
0.01 inch). This adjustment can be helpful if a die cut label sticks to the platen
by means of jagged edges created during removal of a poorly die cut label
when using the tear bar. By controlling how much blank space there is from
TOF, you can control how much the media is called back after it is torn off.
The factory default is 0.40 inches.