Printronix SL4M - Manual (Page 210)

210
Chapter 6 Diagnostics for E0xx, Bad NVM, or ILL NVM Errors
PRINTHEAD HOT
Wait 5 Minutes
Go Online
Yes/No The printhead has
become overheated. 1. Allow the printhead to
cool down for 5 minutes,
then press Pause.
Resume printing.
2. If possible, reduce print
intensity.
3. If problem persists,
contact your authorized
service representative.
PRINTER HARDWARE
NOT COMPATIBLE
Power Off Printer
Remove Cartridge
Yes The printer used to
configure the QCMC
has different hardware
options than the printer
to be configured. Change the hardware
configuration of the new
printer to match the original
printer.
PRINTER UNDER
REMOTE CONTROL
Yes Indicates that PNE
software has control of
the printer. Press any key on the printer.
PROGRAM IS NOT
COMPATIBLE WITH THIS
PRINTER
Repeat Download
No An attempt was made
to download a
non-compatible
program file.
Try downloading again. If
problem persists, contact
your authorized service
representative.
QCMC DATA ERROR
ON EMC
Delete & Resave
QCMC Data
Yes The data on the QCMC
is corrupted. Delete the existing QCMC
and recopy from the original
printer.
QCMC DETECTED
Copy to Printer?
Yes...Press <ENTER>
No...Press <CANCEL>
Yes The printer detected a
QCMC with a saved
configuration. To configure the printer with
the QCMC, press the Enter
key, otherwise press the
Cancel key.
QCMC DETECTED
Save to QCMC?
Yes...Press <ENTER>
No...Press <CANCEL>
Yes The printer detected a
QCMC cartridge
without a saved image. If the printer is completely
configured with the desired
state, press the Enter key. If
you do not wish to save at
this time, press Cancel.
REWINDER FULL
Remove Roll Yes The Rewinder Full
Sensor has detected a
roll full condition. Remove the roll from the
rewind spindle.
Table 15. Fault Messages
Displayed Message
Can User
Correct?
Explanation Solution