Printronix SL4M User Manual
Page 31
Loading Fanfold Media
31
7.
Thread the media under the media damper, through the media sensor
assembly, and then between the platen (rubber drive roller) and the
printhead. You can also refer to the label inside the media cover for media
loading instructions.
CAUTION
If the media width guide locking knob is too loose or is removed, the
media width guide will fall off the printer.
8.
Turn the media width guide locking knob counterclockwise just enough to
slide the media width guide, and no more.
9.
Position the metal guide lightly against the outside edge of the installed
media and tighten the locking knob by turning it clockwise.
10. Check the horizontal position of the media sensor assembly
(see “Positioning the Media Sensors” on page 44).
Media Sensor
Assembly
Media Sensor
Handle
Media
Damper
Platen
Media Width
Guide
Locking Knob