Printronix SL4M - Manual (Page 108)

108
Chapter 4 PRINTER SETUP Menu
PRINTER SETUP Submenus
PAA: Status
See “Printronix Application Adapter” in the PrintNet Enterprise Suite User’s
Manual .
• Disable (factory default). The printer disables the use of PAA
functionality.
• Enable . The printer enables the use of PAA functionality.
Power Saver Time
The time interval you specify for this parameter sets the amount of idle time
before the printer goes into Power Saver mode.
Pressing any key removes the power saver message from the control panel.
Sending a print job to the printer also turns off power saver mode.
The options are 1, 5, 10, 15, 30, 45, 60, and 240 minutes.
The factory default is 15 minutes.
Pwr Save Control
Pwr Save Control allows you to enable and disable Power Saver mode. If
enabled, the menu for Power Saver Time is in effect.
The options are Enable (factory default) and Disable.
Display Language
This parameter chooses the language that will appear on the LCD: English,
German, French, Italian, Spanish, Portuguese, Simplified Chinese, Traditional
Chinese, or Korean.
The factory default is English.
Alarm
• On (factory default). An audible alarm sounds (3 beeps) when a fault
occurs, such as a paper jam.
• Cont. Beep . A continuous audible alarm sounds when a fault occurs,
which can be stopped by pressing CLEAR.
• Off . No audible alarm sounds.
Power-up State
• Online (factory default). The printer powers up in the online state.
• Offline . The printer powers up in the offline state. This selection must be
saved as a power-up configuration to be used.