Printronix SL4M - Manual (Page 223)

Memory
223
Memory
Optional Expanded Memory Cartridge
CAUTION You must power off the printer before you install or remove the EMC, or
you may damage the EMC and the printer. If you remove the EMC after
powering on the printer with the EMC installed, the fault message
"MEMORY REMOVED Check EMC" will display. You cannot clear this
message by reinserting the EMC. You must cycle power.
The expanded memory cartridge (EMC) is a user installable 32MB memory
storage cartridge that provides additional flash memory for downloading
forms, logos, and fonts. The EMC can be ordered as a factory option kit or as
a field upgrade kit that allows users to increase the printer flash memory
capacity. Refer to page 238 to 240 for installation instructions. The EMC can
also come as a preloaded factory kit with one of three Asian TrueType fonts
(see “DBCS Character Sets and Fonts” on page 229), one of four Andalé
TrueType fonts, or the QCMC option.
Media Cutter Option
The media cutter is designed to cut tags and label liner. Avoid cutting through
the adhesive backed portion of any media.
Flash Memory (standard) 8MB fixed on Controller PCBA
DRAM (standard) 32MB fixed on Controller PCBA
Typical Life More than 1,000,000 cuts
Warranty 500,000 cuts
Environment Same specifications as printer
Cutting Method Single-edged blade, up/down slice motion
Media Thickness Range 0.0025 to 0.010 in. (0.064 to 0.254 mm)
Media Width Range 1.00 to 5.15 inches (25.4 to 130.8 mm)
Media Length Range 1.00 to 99 in. (25.4 to 2515 mm)