Printronix SL4M - Manual (Page 170)

170
Chapter 5 Downloading TrueType Fonts
8. Start a command prompt session. (The Start Menu icon is usually labeled
Command Prompt or MS-DOS Prompt .)
9. Make note of the file name with the .dwn extension of each file you want
to download to the printer.
10. At the command prompt type:
copy /b filename.dwn LPT1 <Enter>
(where filename .dwn is file name you noted in step 9.)
NOTE: If you are loading the file using the LPT2 port on the computer, type
the following command:
copy /b filename.dwn LPT2 <Enter>
(where filename .dwn is a file you noted in step 9.)
If you are loading the file using the serial port on the computer, type
the following commands:
mode COM1:9600,N,8,1,P <Enter>
copy /b filename.dwn COM1 <Enter>
(where filename .dwn is a file you noted in step 9.)
The 9600 baud rate is the only selection some systems can use. The
baud rate information entered in the above commands must match the
Baud Rate setting (in the SERIAL PORT menu) saved in the Power-Up
Config.
You can download the fonts one at a time by entering one file name per
the
copy command or you can copy multiple files in one copy command.
To download one file at a time, enter the following at the command
prompt:
copy /b filename.dwn LPT1 <Enter>
To download multiple files, enter the following at the command prompt,
for example:
copy /b filename1.dwn+filename2.dwn+...LPT1 <Enter>
11. While the font file is copied into the flash memory, the printer LCD informs
you of the load process and status. When the new file is successfully
loaded into memory, the printer will reset itself and go online.
12. To verify that the fonts have been downloaded:
NOTE: Admin User must be set to Enable in the PRINTER SETUP menu.
a. Perform a configuration printout.
— OR —
b. Select PRINTER SETUP

Main FFS

View File List or
PRINTER SETUP

EMC FFS

View File List , depending on
whether you downloaded to the main flash or the optional EMC flash
cartridge. The new file names will appear with the same file name you
downloaded, but with a
.ttf extension.
NOTE: The TrueType font typefaces cannot be selected via the printer
control panel. They can only be selected via a software command
from the host.