Printronix SL4M - Manual (Page 284)

284
Appendix G Communication Notices
This product contains an intentional radiator with the following parameters:
Operating Frequency: 902 to 928 MHz
Typical RF Power: 100 milliwatts
Maximum RF Power: 700 milliwatts
Canada
This Class B digital apparatus complies with Canadian ICES-003 and
RSS 210.
Cet appareil numérique de la classe B est conforme à la norme NMB-003
du Canada.
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
This device has been designed to operate with the antennas listed below, and
having a maximum gain of –12 dBi. Antennas not included in this list or having
a gain greater than –12 dBi dB are strictly prohibited for use with this device.
The required antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its
gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that permitted for successful communication.
CE Notice (European Union)
Marking by the CE symbol indicates compliance of this Printronix system to
the EMC Directive and the Low Voltage Directive of the European Union.
Such marking is indicative that this Printronix system meets the following
technical standards:
• EN 300 220-1 (2000), Electromagnetic Compatibility and Radio Spectrum
Matters; Short Range Devices; Radio equipment to be used in the
25 MHz to 1000 MHz frequency range with power levels ranging up to
500 mW.
• EN 55022 — “Limits and Methods of Measurement of Radio Interference
Characteristics of Information Technology Equipment.”
• EN 55024 — “Electromagnetic Immunity Requirements for Information
Technology Equipment”
• EN 60950 — “Safety of Information Technology Equipment.”
Tested To Comply
With FCC Standards
Printronix SL4M and T4M
FOR HOME OR OFFICE USE