Printronix SL4M User Manual
Page 239
Loading New Firmware on the Printer
239
Figure 9. Installing the EMC
3.
Press the release tab and remove the EMC slot cover.
4.
Plug the EMC (with the arrow positioned as shown) into the EMC slot.
5.
Install the EMC slot cover.
6.
Lower the media cover.
7.
Set the printer power switch to
|
(On).
8.
Make sure the Enter key is not locked and that Admin User is set to
Enable.
9.
Install the EMC:
a.
If installing a QCMC, follow the instructions shown on the printer
control panel to set up the Quick Change feature. See “Saving the
Printer’s Configuration to the QCMC” on page 233.
b.
If the EMC contains fonts, verify that the fonts are present by doing
the following:
i.
When ONLINE or OFFLINE displays on the printer’s LCD,
press
to enter Menu mode.
ii.
Press the Right key until
PRINTER SETUP displays.
iii. Press
↵
to enter the
PRINTER SETUP menu.
EMC Slot
Cover
EMC Slot
EMC
Arrow
Release
Tab
A